CreateConnectModifier

This command creates a ConnectModifier to connect vertices and edges.

Using This Command

Select set of edges or vertices and apply the command.

  1. Select a set of edges or vertices. Minimum of 2.
  2. Right click and choose Connect from the listed options.
  3. The software adds a ConnectModifier to the mesh construction history.
  4. Edges or vertices are connected. Edges are connected at their midpoints.

Figures

The order of selection must be sequential or the connection operation may not produce the desired results.

Figure 1.1. The edges before connection: Before Creating A ConnectModifier Figure 1.2. The results after connection: After Creating A ConnectModifier Figure 1.3. Before: ConnectModifier Example Figure 1.4. After: ConnectModifier Example Figure 1.5. Before: ConnectModifier Example Figure 1.6. After: ConnectModifier Example Figure 1.7. Before: ConnectModifier Example Figure 1.8. After: ConnectModifier Example Figure 1.9. Before: ConnectModifier Example Figure 1.10. After: ConnectModifier Example

Registration

Command registration information is as follows:

Category TypeInformation
ImplementationSCRIPT
ModuleMODIFIER_SCRIPTS.SSL
CategoryModifier Commands
GUID{1F91F927-F612-46D4-A453-4B81096121A9}
Source NameCreateConnectModifier
Interface NameConnect
CoreNo
SampleYes
AccessModify [edge/vertex] option on main menu or [edge/vertex] command menu.

See Also

For more information: