DrawFreehandLinearCurve

This command sets the software to draw a freehand linear curve.

Using This Command

Select this command from the Draw option on the main menu.

  1. Invoke the command.
  2. Left click on the worksheet to set the first point of the curve.
  3. Move the cursor and left click to add the second, third, fourth ... points.
  4. Right click when you are finished.
  5. NOTE: The draw mode automatically closes a curve when you reach 32 sections.
  6. NOTE: This draw mode does not automatically "close" the curve boundary.

Registration

Command registration information is as follows:

Category TypeInformation
ImplementationC++
ModuleBASETOOLS.DLL
CategoryDraw Commands
GUID{1F91F8B2-F612-46d4-A453-4B81096121A9}
Source NameDrawFreehandLinearCurve
Interface NameDraw Freehand Linear
CoreYes
SampleNo
AccessDraw option on main menu.