ModifierReplaceInputs

This command allows you to replace the input geometry referenced by a modifier.

Using This Command

Follow these instructions.

1. Select the new face-set, edge-set, or vertex-set for the modifier.
2. Hold down CTRL.
3. Right click over the modifier.
4. Select Replace Modifier Inputs from the listed options.

Registration

Command registration information is as follows:

Category Type	Information
Implementation	C++
Module	PARAMETRIC.DLL
Category	Modifier Commands
GUID	{1F91F9C4-F612-46D4-A453-4B81096121A9}
Source Name	ModifierReplaceInputs
Interface Name	Replace Modifier Inputs